Mazdaspeed 6 intake manifold removed
Mazdaspeed 6 intake manifold removed
mx6 mods open,intake,open stock exhaust, nitrous mazdaspeed mods upgraded intercooler,bc,cpe ecu,tbe,intake maxima mods cam,upgraded intake ...
radiator support removal - Mazda 6 Forums
Changes: 3.25" ETS TMIC, Forge BPV, SU Boost Tubes, RPM Prototype Sport Springs, TWM Short Shifter and bushings, SU motor mount, Nokya H11 yellow foglights, RX8 wheels on 235/40 General Exclaim UHP, rolled fender lips, Fujita CAI, 3" custom single outlet exh with 2 (yes, 2) Magnaflow resonators, SpiralFlow and Aeroturbine muffler, Osram Silverstar H1 high beams, Turn signal mod, MazdaSpeed6 badge removed At this point you'll have to undo the main bumper beam but this is what the radiator shroud is also bolted to. You need to unbolt the shroud from the beam but then there is nothing to support the shroud and radiator/condensor assembly. The shop manual says to rig up some wires or rope hanging from the ceiling to support the shroud assembly....
SilverDemon/JM Fabrications Intake Manifold ... - Mazda 6 Forums
You "could" modify a manifold, but you would have to fabricate a pipe from the top mount, or front mount, and TB. After all that, might might as well have just designed one to work properly with the air flow of this motor, not to mention the cheaper route, rather than trial and error with a rigged manifold. Those modifications could potentially lessen the integrity of a manifold anyways.