Intake Manifolds
Dorman OE Solutions 615-178 Intake Manifold
(Misc.) DORMAN
Includes integrated gasket design
Torque specifications & bolt tightening sequence are provided for easier installation (where applicable)
Features a reinforced aluminum coolant crossover to eliminate corrosion and vibration
Re-engineered by Dorman with heat-resistant molding to reduce both warping and coolant leaks
Price:
$362.99
$180.35
Customer Reviews:
-
GREAT BUY FOR FORD/LINCOLN/MERCURY OWNERS
I bought this for my 96 Lincoln after I found out that my intake manifold cracked and it was past the deadline for the class action settlement from Ford. There are great instructions on the internet for the installation and it took about 7 hours from start to finish. The only problem was that one... -
it works..
After over 100K miles (and days after having replaced a coolant leaking intake manifold gasket) on the second plastic cross over manifold on my mustang I noticed a small crack near the passenger side temp sensor that was weeping coolant and upon disassembly a three inch crack in progress where...
Answers
go to the autoparts store and pick up some JB Weld. That stuff works pretty good on plastic.
It's a well known problem on the Crown Vic, you will need to replace the intake. Good news you can now get them aftermarket at most parts stores.
Price:
$74.60
$30.10
Backed by limited lifetime warranty
Designed to supply air and fuel to cylinder
Constructed from durable material
Ensures Longevity
Stringently tested for fit and function
Price:
$86.99
$54.52
PermaDryPlus Int manifold gskts incl
Upper set incl
Per Car Qty:1
Lower set
2000 Ford Crown Victoria Intake Manifold – Cross-Over Channel ...
Ford: 1996-1997 THUNDERBIRD 1996-2001 CROWN VICTORIA, MUSTANG 2002 EXPLORER ISSUE Some vehicles may exhibit an Intake Manifold crossover (first runner) coolant seepage condition. This may be caused by a crack in the Intake Manifold coolant crossover. ACTION Inspect the suspect Intake Manifold for a coolant leak at the first runner cross-over area (Figure 1). If coolant seepage is found in this area, order the appropriate Service Kit and install parts, by referring to the appropriate Model Year Workshop Manual (Section 303-01). 4.6L 2V INTAKE MANIFOLD INSPECTION/REPLACEMENT Refer to Figure 1 for inspection of coolant seepage. If seepage is found, order one of the following Service Kits to repair.
Buying a 2000 Crown Vic.... - Crownvic.net
I have seen that one in Burlingame for a few days, so I imagine it's still available. I wouldn't buy a 2006 because I have only heard problems about their trannies, and it's at that point which they seem to fail. When you do go see the car, take it for a HARD test drive to see how things like the tranny and engine are holding up. Also check the tranny fluid, if it's red and doesn't smell horrible, you're good.
